Megger AVO410 Manuel d'utilisateur

1mMAVO410Digital multimeterDigitale MultimeterMultimèter numériqueMultímetro digitalesDigitale multimeterUser manualBedienungsanleitungManuel utilisat

10MAINTENANCETo clean the instrument, do not immerse in water, periodically wipe the case with a damp cloth and mild detergent. Dirt in the terminals

11ELECTRICAL SPECIFICATIONSAccuracy is ± (% reading + number of digits) at 23 ºC ±5 ºC, less than 80% R.HDC/AC voltsRange DC accuracy AC accuracy600

12Overload protectionA input: 10 A (500 V) fast blow fuseµA input: 600 V rms*1 AC conversion type: Conversion type and additional specificati

13FrequencyRange **Sensitivity Overload protection6000 Hz 60.00 KHz600.0 KHz6.000 MHz 250 mV rms60.00 MHz 1 V rmsOverload protection: 600 V rms

14REPAIR AND WARRANTYThe instrument contains static sensitive devices, and care must be taken in handling the printed circuit board. If an instrument’

15Approved Repair CompaniesA number of independent instrument repair companies have been authorised for repair work on most Megger instruments, using

70MMegger LimitedArchcliffe RoadDover CT17 9EN T: 01304 502101F: 01304 207342Megger4271 Bronze Way,Dallas, Texas 75237-1019 USA T: 1-800-723-2861F: 1-

2G SAFETY WARNINGSSafety warnings must be read and understood before instrument is used.The following safety information must be observed to insure ma

3Safety warnings ... 2Symbols used on instrument ...

4IntroductionThank you for purchasing the Megger AVO410 Digital Multimeter.For your own safety and to get the maximum benefit from your instrument,plea

5Meter description1. 6000 counts LCD display.2. Push buttons for features3. Selection switch 4. Input terminal for all other functions (Red)5. In

6OperationAC VOLTAGE MEASUREMENTS1. Set the function switch to the V AC position (AUTO, T-RMS and AC volts will appear on the display).2. Insert

74. For continuity connect the test probes to the cable or circuit to be tested. (Polarity is not important).5. The AVO410 will emit a tone if co

8FREQUENCY MEASUREMENTS1. Set the function switch to the Hz position (AUTO and Hz will appear on the display).2. Insert the black test lead in the

9MIN MAXThe MIN MAX function enables the user to display both a minimum and a maximum measured reading. To activate, first select a function and make a